Clock Slip Counters; Table 4-10 Rsvp-Based Admission Control Feature Cli Commands - Cisco Voice Interworking Services (VISM) Installation And Configuration Manual

Chapter 4 Configuring VISM Features
•
•
Note VISM supports RSVP in the VoIP switching operating mode only, with a 5 calls per second
limitation; RSVP is not supported in the VoIP trunking operating mode.
In previous releases of VISM software, the following connection data is returned in response to the call
agent initiated DLCX, and gateway initiated DLCX or AUCX commands:
•
•
•
•
VISM Release 3.0(0) provides the following additional connection data:
•
•
•
Use the commands in

Table 4-10 RSVP-Based Admission Control Feature CLI Commands

Command
cnfrsvp
cnfrsvprefreshmiss

Clock Slip Counters

The clock counter information feature allows you to clear the current frame slip counters for a specified
VISM or VISM-PR card line and display the current frame slip counters for a specified VISM or
VISM-PR card line. Use the new clrslipcnt and dspslipcnt to use this feature.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Tear down originated or established unidirectional resource reservations.
Tear down accepted resource reservations.
Number of packets sent
Number of octets sent
Number of packets received
Number of octets received
Number of packets lost
Inter-arrival jitter—If a DSP is configured to operate in the adaptive jitter buffer mode, the jitter data
provided indicates the delay that the jitter-algorithm is adapted to. If a DSP is configured to operate
in the fixed jitter buffer mode, the jitter data provided indicates the value that was configured when
the channel was opened.
For adaptive mode you can use the value to indicate that the configured initial delay value
Note
is too low or too high, since the algorithm adapts according to the actual network jitter.
Average transmission delay (latency)
Table 4-10
Description
Configures RSVP for a specified connection.
Configures the number of times VISM waits for a missed RSVP minimum
refresh message for a specified connection.
to configure the RSVP-based admission control feature.
Cisco VISM Installation and Configuration Guide
Configuring Additional VISM Features
4-67