Chapter 5
CLI Commands
cnfds0loop
To configure a loopback type for a specified line and DS0, use the cnfds0loop command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
ds0-num
loopback-type
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the loopback type of line 2, DS0 12 is configured as remote:
cnfds0loop 2 12 2
Related Commands
There are no related commands.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfds0loop line-num ds0-num loopback-type
Line number of the channel to be configured for a loopback type; in the range from
1 to 8.
DS0 number of the channel to be configured for a loopback type. It can be a value
from one of the following ranges:
1 to 24 for T1 lines
•
1 to 31 for E1 lines
•
The type of loopback to be used on the channel. It can be one of the following
values:
1 = No loopback
•
2 = Remote loopback
•
•
3 = Local loopback
Cisco VISM Installation and Configuration Guide
cnfds0loop
5-143