Table of Contents
Advertisement
Chapter 5
CLI Commands
dspsrcppeer
To display the peer configuration data for a specified Simple Resource Control Protocol (SRCP) peer
(call agent), use the dspsrcppeer command in the VoIP switching/trunking operating mode.
Syntax Description
peer-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the peer configuration data for the call agent identified by peer
number 4 is displayed:
dspsrcppeer 4
Related Commands
Command
dspsrcpcnt
dspsrcpcnts
dspsrcppeers
dspsrcpport
dspsrcpretry
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspsrcppeer peer-num
Peer (call agent) identification number. It can be a value from 1 to 8.
Description
Displays the SRCP message counters (statistics) for a specified call agent.
Displays SRCP message counters (statistics) for all known call agents.
Displays the peer configuration data for all known SRCP peers (call agents).
Displays the local UDP port number used by the SRCP on VISM.
Displays the card level SRCP retransmission parameters—maximum number
of retransmission attempts, minimum timeout, and maximum timeout.
Cisco VISM Installation and Configuration Guide
dspsrcppeer
5-431
Advertisement
Table of Contents
