Table of Contents
Advertisement
Chapter 4
Configuring VISM Features
Complete the following steps to add and configure CCS signaling:
Step 1
Type the addccs command, line-num, ds0-num, and lcn argument values, and press Enter to add a CCS
channel to your VISM card. Specify the arguments with the following values:
•
line-num: In the range from 1 to 8
•
ds0-num:
–
–
lcn: In the range from 131 to 510
•
If you are configuring CCS for the AAL2 trunking operating mode, the CCS configuration is complete.
Step 2
Proceed to the
the VoIP switching operating mode, you must create a Q.921 link access protocol for the D channel
(LAPD) link for the channel and specify its argument values. Proceed to
Step 3
Type the addlapd command, line-num, ds0-num, |lapd-side| and |lapd-app-type| argument values, and
press Enter to add an ISDN PRI channel on a DS1/DS0.
Specify the arguments with the following values:
line-num: Type the value used in
•
ds0-num: Type the value used in
•
|lapd-side|:
•
–
–
•
|lapd-app-type|:
–
–
Type the cnflapdtype command, line-num, ds0-num, and lapd-type argument values, and press Enter to
Step 4
specify the LAPD stack type. Specify the arguments with the following values:
line-num: Type the value used in
•
ds0-num: Type the value used in
•
lapd-type:
•
–
–
–
–
–
–
–
–
–
–
–
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
In the range from 1 to 24 for T1
In the range from 1 to 31 for E1
"Configuring Bearer Processing" section on page
1 = Network (default)
2 = User
1 = PRI (default)
2 = GR-303 (currently unsupported)
1 = ITU
3 = ATT5ESSPRA
4 = ATT4ESS
6 = NTDMS100PRA
7 = VN2 or 3
8 = INSNet
9 = TR6MPC
10 = TR6PBX
12 = AUSP
13 = NIL
14 = SSETSI
Step
1.
Step
1.
Step
1.
Step
1.
Cisco VISM Installation and Configuration Guide
Configuring VISM Features
4-27. If you are configuring CCS for
Step
3.
4-21
Advertisement
Table of Contents
