Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfxgcppeer
To configure the User Datagram Protocol (UDP) port number used to send gateway-initiated messages
to the call agent, use the cnfxgcppeer command in the VoIP switching/trunking and switched AAL2
PVC operating modes.
Syntax Description
mgc-num
protocol-num
remote-udp-pnum
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that call agent 1 is configured with protocol number 3 and remote UDP
port number 1168:
cnfxgcppeer 1 3 1168
Related Commands
Command
cnfdisctimers
cnfmgcgrpprotocol
dspdisctimers
dspxgcppeers
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfxgcppeer mgc-num protocol-num remote-udp-pnum
A number by which the call agent is identified in the range from 1 to 8.
Protocol number. It can be one of the following values:
1 = MGCP 0.1
•
2 = SGCP 1.1+
•
•
4 = SGCP 1.5
•
5 = MGCP 1.0
UDP port number. In the range from 1025 to 65535. (Default = 2427)
Description
Specifies the wait delay times for the disconnected procedure, restart in
progress command—initial, minimum, and maximum timer values.
Configures call agent group protocol data.
Displays the Restart in Progress command disconnect type method wait delay
times.
Displays all UDP peer ports used by SGCP and MGCP.
Cisco VISM Installation and Configuration Guide
cnfxgcppeer
5-237
Advertisement
Table of Contents
