Dsp Download Failure - Cisco Voice Interworking Services (VISM) Installation And Configuration Manual

Chapter 6 Troubleshooting Tips
20
21
22
25
26
27
28
29
30
Use the PXM dsplog command to show a card mismatch log entry, logged by VISM card on slot 5, as
follows:
09/09/2001-00:01:47 05 dsplog VISM-6-9025
VISM going to standby : Config. Mismatch between PXM and VISM
Use the VISM dspcd command to display the following information:
NODENAME.1.5.VISM8.s > dspcd
ModuleSlotNumber:
FunctionModuleState:
FunctionModuleType:
FunctionModuleSerialNum:
FunctionModuleHWRev:
FunctionModuleFWRev:
FunctionModuleResetReason: WatchDog timeout reset
LineModuleType:
LineModuleState:
mibVersionNumber:
configChangeTypeBitMap:
cardIntegratedAlarm:
pcb part no - (800 level): 800-03530-01
pcb part no - (73 level):
Fab Part no - (28 level):
PCB Revision:
Daughter Card Information:
Daughter Card Serial Number: CAB12345678
pcb part no - (73 level):
Fab Part no - (28 level):
PCB Revision:

DSP Download Failure

Use the PXM dsplog command to determine if the minimum number (five) of the DSPs failed to
download. The terminal displays results similar to the following:
NODENAME.1.7.PXM.a > dsplog
01/01/2001-00:02:10 05 tDspmDl
DSPM task errors
If the number of DSPs (six in the above case) is greater than five, the card will fail to be in the active
state. If this condition happens repeatedly, replace the card.
Use the following PXM dspcds command, and the results, to determine the current state of VISM DSPs:
NODENAME.1.7.PXM.a > dspcds
Slot
----
1.1
1.2
1.3
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
------> No configuration file exist for this slot
------> No configuration file exist for this slot
------> No configuration file exist for this slot
------> No configuration file exist for this slot
------> No configuration file exist for this slot
------> No configuration file exist for this slot
------> No configuration file exist for this slot
------> No configuration file exist for this slot
------> No configuration file exist for this slot
5
Mismatch
VISM-8E1
CAB12345678
0.13
2.2.10g.pm
Missing
Not Present
20
CardCnfChng, LineCnfChng
Clear
73-03021-01
28-02492-01
01
: 6 DSPs failed to download
CardState CardType
----------- --------
Empty
Empty
Empty
73-03022-01
28-02493-01
01 value = 34 = 0x22 = '"'
VISM-6-9193
CardAlarm Redundancy
--------- -----------
Clear
Clear
Clear
Cisco VISM Installation and Configuration Guide
Symptoms and Solutions
<------
<------
<------
<------
<------
<------
<------
<------
<------
6-7