Table of Contents
Advertisement
dspsrcpport
dspsrcpport
To display the local User Datagram Protocol (UDP) port number used by the Simple Resource Control
Protocol (SRCP) on VISM, use the dspsrcpport command in the VoIP switching/trunking operating
mode.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the local UDP port number used by the SRCP is displayed:
dspsrcpport
Related Commands
Command
dspsrcpcnt
dspsrcpcnts
dspsrcppeer
dspsrcppeers
dspsrcpretry
Cisco VISM Installation and Configuration Guide
5-434
dspsrcpport
Description
Displays the SRCP message counters (statistics) for a specified call agent.
Displays SRCP message counters (statistics) for all known call agents.
Displays the peer configuration data for a specified SRCP peer (call agent).
Displays the peer configuration data for all known SRCP peers (call agents).
Displays the card level SRCP retransmission parameters—maximum number
of retransmission attempts, minimum timeout, and maximum timeout.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
