Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 380

cnfxgcpmwd
cnfxgcpmwd
To configure the maximum waiting delay (MWD) value used for sending a Restart in Progress (RSIP)
message to the call agent, use the cnfxgcpmwd command in the VoIP switching/trunking operating
mode.
Syntax Description
max-wait-delay
Command Modes VoIP switching/trunking
Usage Guidelines
Use this command to limit the number of RSIP messages sent to the call agent when an MGX 8000 Series
platform configured with multiple VISM cards is started or reset. Each VISM card waits a random
amount of time (up to a maximum specified by this command) before sending an RSIP message.
Examples
The following example shows that the maximum waiting delay time to send RSIP messages to the call
agent is 300 ms:
cnfxgcpmwd 300
Related Commands Command
dspxgcpcnf
Cisco VISM Installation and Configuration Guide
5-236
cnfxgcpmwd max-wait-delay
Maximum wait delay time (defined in milliseconds) to send an RSIP message to
the call agent. It can be in the range from 0 to 600000. (Default = 10000)
Description
Displays previously configured SGCP/MGCP timeout and retry count values.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands