Table of Contents
Advertisement
dspvismparam
dspvismparam
To display VISM card configuration parameters, use the dspvismparam command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration parameters of the current VISM card are displayed:
dspvismparam
VISM mode:
VISM features Bit Map:
CAC flag:
DS0s available:
Template number:
Percent of functional DSPs:
IP address:
Subnet mask
RTCP report interval:
RTCP receive multiplier:
RTP receive timer:
ControlPrecedence/Tos:
BearerPrecedence/Tos:
Aal2 muxing status:
Tftp Server Dn
Aggregate Clipping
Aggregate Svc Bandwidth
Codec negotiation option
Profile negotiation option
VAD Duty Cycle
VAD Tolerance
CALEA:
The DS0 available parameter value is applicable to AAL2 trunking operating mode only. The RTCP
Note
report interval, RTP receive timer, ControlPrecedence/Tos, and BearerPrecedence/Tos parameter
values are applicable to VoIP switching/trunking operating mode only.
Related Commands
Command
addcon
cnfcac
cnfcalea
Cisco VISM Installation and Configuration Guide
5-456
dspvismparam
Description
Adds a PVC connection between a VISM card and any SM or PXM card.
Enables or disables the CAC feature on a VISM card.
Enables or disables the CALEA feature on the current VISM card.
voipSwitching
0x5ac
enable
192
2
100
64.68.2.1
255.255.255.252
1000 msec
3
disable
0x60
0xa0
disable
TFTPDOMAIN
enable
0
1
1
61
100
enable
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands
Advertisement
Table of Contents
