Chapter 5
CLI Commands
dsprtpconnstat
To display the Real-Time Transport Protocol (RTP) connection statistics for a specified endpoint, use
the dsprtpconnstat command in the VoIP switching/trunking, switched AAL1 SVC, switched AAL2
SVC, switched AAL2 PVC, AAL2 trunking, VoIP and switched ATM AAL1 SVC operating modes.
Syntax Description
endpt-num
Command Modes
VoIP switching/trunking, switched AAL1 SVC, switched AAL2 SVC, switched AAL2 PVC, AAL2
trunking, VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows the RTP connection statistics for endpoint 202:
dsprtpconnstat 202
No. of RTP Packets Sent =
No. of RTP Packets Received = 0
No. of Octets Sent =
No. of Octets Received =
No. of RTP Packets Lost =
Interarrival Jitter =
Latency =
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsprtpconnstat endpt-num
Endpoint number. It can be a value from one of the following ranges:
•
For template number 1:
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•
For template number 3:
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
For template number 4:
•
For VISM-PR, from 1 to 144
–
0
0
0
0
80
0
Cisco VISM Installation and Configuration Guide
dsprtpconnstat
5-411