Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfaal2timerparams
To configure the holdover time for VAD in milliseconds before activating silence suppression on an
AAL2 PVC, use the cnfaal2timerparams command in the switched AAL2 PVC operating mode.
Syntax Description
vad-init-timer
cid-fill-timer
Command Modes
Switched AAL2 PVC
Usage Guidelines
If AAL2 subcell multiplexing is disabled with the cnfaal2subcellmuxing command, executing this
command produces no affect.
Examples
The following example shows that the VAD holdover timer is set for 500 ms, and will wait up to 50 ms
for a cell to fill when the next packet is not ready:
cnfaal2timerparams 500 50
Related Commands
There are no related commands.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfaal2timerparams vad-init-timer cid-fill-time
The VAD holdover timer (defined in milliseconds) in the range from 250 to 65535.
Maximum wait time for cell content filling when the next packet is not ready
(defined in milliseconds), in the range from 5 to 100.
Cisco VISM Installation and Configuration Guide
cnfaal2timerparams
5-67
Advertisement
Table of Contents
