Table of Contents
Advertisement
dspendpt
dspendpt
To display configuration data of a specified VISM card endpoint, use the dspendpt command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
endpt-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data of endpoint number 120 is displayed:
dspendpt 120
EndptNum:
EndptLineNum:
EndptName:
EndptSpeed:
EndptState:
EndptChannelMap: 1
EndptEnable:
EndptLoopback:
Note
The EndptChannelMap value is represented by a hexadecimal number, where each DS0 is a power
of 2—EndptChannelMap = 2
Cisco VISM Installation and Configuration Guide
5-346
dspendpt endpt-num
Endpoint number. It can be a value from one of the following ranges:
For template number 1:
•
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
For template number 3:
•
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 4:
–
For VISM-PR, from 1 to 144
120
1
T1-1/1@cisco.com
64 kbps
active
active
disabled
DS0 number
.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands
Advertisement
Table of Contents
