Boot Code Upgrade Procedure With Pxm1E And Pxm45 Cards; Vism/Vism-Pr Downgrade Procedure - Cisco Voice Interworking Services (VISM) Installation And Configuration Manual

Chapter 1 Overview of the VISM and VISM-PR Cards
To commit the new download to the VISM-PR card, enter the commitrev command.
Step 6
commitrev sm-primary-slot-num new-rev
You have completed the steps. Proceed to the
Cards, page

Boot Code Upgrade Procedure with PXM1E and PXM45 Cards

Complete the following steps to upgrade the new backup boot code when you are using PXM1E or
PXM45 cards in your MGX 8000 Series chassis:
Complete the steps in the
Step 1
Log in to the PXM1E or PXM45 card.
Step 2
Use the burnboot sm-primary-slot-num new-rev command, where sm-primary-slot-num is the slot
Step 3
number of the VISM-PR card you want to upgrade and new-rev is the firmware version number of the
new VISM software, to upgrade the VISM-PR boot code.
The VISM-PR card automatically resets and becomes active with the latest boot code image. You have
completed the boot code upgrade procedure.

VISM/VISM-PR Downgrade Procedure

Use this procedure to downgrade VISM software from software Release 3.0 to an earlier VISM release.
By following the downgrade procedure described here, the configurations are retained after the
downgrade.
The configurations that existed with old-rev firmware should have been saved earlier. You
Note
cannot downgrade from VISM-PR to VISM.
Complete the following steps to downgrade the VISM software from software Release 3.0 for
VISM/VISM-PR to Release 2.2, 2.1, 2.0, or 1.5:
Step 1 If the VISM card is in a redundancy group, remove the redundancy.
delred <SM slot#>
Step 2 Download the old-rev firmware onto the MGX shelf.
Step 3 Execute the PXM clrsmcnf command:
clrsmcnf <SM slot#>
where:
SM slot# is the slot number of the VISM card to be downgraded.
The VISM card resets on executing this command. Wait for the card to come active.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
1-25.
VISM-PR Upgrades with PXM1E and PXM45, page 1-23
Boot Code Upgrade Procedure with PXM1E and PXM45
Cisco VISM Installation and Configuration Guide
Software Upgrades
section.
1-25