Table of Contents
Advertisement
Chapter 5
CLI Commands
bearer-tos
vad-enable
vad-timer
ecan-enable
cas-trans
dtmf-trans
idle-code-sup
Command Modes
VoIP switching/trunking
Usage Guidelines
The G.723.1 codecs are supported for VISM-PR cards and are not supported for VISM cards.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
(Optional) Bearer type of service (ToS). It can be one of the following values:
•
0 (Default)
1
•
2
•
4
•
8
•
(Optional) Enables or disables voice activity detection (VAD). It can be one of
the following values:
1 = On
•
•
2 = Off (Default)
(Optional) The VAD holdover timer (defined in milliseconds) in the range from
250 to 65535.
(Optional) Enables or disables echo cancellation (ECAN). It can be one of the
following values:
•
1 = On (Default)
2 = Off
•
(Optional) Enables or disables CAS signaling transportation. It can be one of the
following values:
1 = On (Default)
•
2 = Off
•
(Optional) Enables or disables DTMF tone transportation. It can be one of the
following values:
•
1 = On (Default)
•
2 = Off
Note
The dtmf-trans argument value must be set to 1 (on) when the codec-type
is configured for codecs other than G.711 and G.726.
(Optional) Enables or disables idle code suppression for the CID. It can be one
of the following values:
•
1 = On
2 = Off (Default)
•
Cisco VISM Installation and Configuration Guide
cnfrtpcon
5-199
Advertisement
Table of Contents
