Table of Contents
Advertisement
Configuring VISM Features
Type the cnfds0localcas command, line-num, ds0-num, local-cas-enable, and local-cas-pattern
Step 10
argument values, and press Enter to configure a local CAS bit pattern for a T1 line and DS0.
Note
Specify the arguments with the following values:
line-num: 1 to 8 (T1 lines only)
•
ds0-num: 1 to 24
•
•
local-cas-enable:
–
–
•
local-cas-pattern: In the range from 1 (default) to 15
Note
Type the addcasvar command, var-name, file-name and |source| argument values, and press Enter to
Step 11
add a CAS variant to your VISM card.
Note
Specify the arguments with the following values:
var-name (name of the CAS variant): A text string of 1 to 64 alphanumeric characters.
•
file-name:
•
–
–
–
–
–
–
–
–
–
–
–
–
–
Cisco VISM Installation and Configuration Guide
4-26
The cnfds0localcas command is not allowed if the line is E1 or not enabled, or the DS0 is in
a remote loop state, or if the line signaling type is CAS.
1 = Enable
2 = Disable
If the local-cas-enable argument value = 1, you must specify a local-cas-pattern
argument value.
A file containing the CAS variant information must be downloaded to your MGX 8000 Series
PXM card using a separate application (TFTP) before you can execute this command.
wink_did_dod.o = wink start
ground_start.o = ground start
wink_did_dod_mf.o = wink start multifrequency
q50.o = Q.50
fgd_ea_incoming.o = for endpoints connected to an end office
fgd_ea_outgoing.o = for endpoints connected to an access carrier
fgd_os_e911.o = for endpoints connected to FDG OSS (Feature group D operator services
system.
loop_start.o = loop start
delay_did_dod.o = dial delay, DTMF
delay_did_dod_mf.o = dial delay, MF
immed_did_dod.o = immediate start
immed_did_dod_mf.o = immediate start, MF
In the range from 1 to 32 alphanumeric characters—user configured files only.
Chapter 4
Configuring VISM Features
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Advertisement
Table of Contents
