Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfadapgain
To enable or disable the DSP adaptive gain feature, use the cnfadapgain command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
adap-gain-enable
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures when using this command.
Examples
The following example shows that the adaptive gain feature is enabled:
cnfadapgain 1
Related Commands
There are no related commands.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfadapgain adap-gain-enable
Enables or disables adaptive gain. It can be one of the following values:
1 = On
•
2 = Off
•
Cisco VISM Installation and Configuration Guide
cnfadapgain
5-69
Advertisement
Table of Contents
