Table of Contents
Advertisement
cnfconcac
cnfconcac
To configure connection admission control (CAC) on a previously added connection, use the cnfconcac
command in the AAL2 trunking operating mode.
Syntax Description
lcn
conn-type
Command Modes
AAL2 trunking
Usage Guidelines
You must use the cnfcac command prior to using this command to enable CAC at the card level. If the
PVC has been configured as master, CAC functionality is applied to the master end of the PVC only.
Examples
The following example shows that CAC is configured at the master end of LCN 131:
cnfconcac 131 1
Related Commands
Command
cnfcac
dspconcac
Cisco VISM Installation and Configuration Guide
5-128
cnfconcac lcn conn-type
Logical channel number of the connection; in the range from 131 to 510.
Connection type. It can be one of the following values:
1 = Master
•
•
2 = Slave (Default)
Description
Enables or disables the CAC feature on a VISM card.
Displays CAC configuration data for a connection.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
