Table of Contents
Advertisement
dspds0loop
dspds0loop
To display the loopback type for a specified line and DS0, use the dspds0loop command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
ds0-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the loopback type for line number 1, DS0 number 1 is displayed:
dspds0loop 1 1
ds1 line number:
ds0 number:
ds0 If Index:
loopback value:
Related Commands
There are no related commands.
Cisco VISM Installation and Configuration Guide
5-344
dspds0loop line-num ds0-num
Line number of the channel for which you want to display the loopback type. It
can be in the range from 1 to 8.
DS0 number of the channel for which you want to display the loopback type. It
can be a value from one of the following ranges:
1 to 24 for T1 lines
•
1 to 31 for E1 lines
•
1
1
1
noLoop
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
CLI Commands
Advertisement
Table of Contents
