Table of Contents
Advertisement
Chapter 5
CLI Commands
dspsesstat
To display configuration data about Primary Rate Interface (PRI) backhaul session statistics (counters),
use the dspsesstat command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the statistics (counters) for the PRI backhaul session set number 1 are
displayed:
dspsesstat 1
vismRudpSessionStatNum:
vismRudpSessionAutoResets:
vismRudpSessionRcvdAutoResets:
vismRudpSessionRcvdInSeqs:
vismRudpSessionRcvdOutSeqs:
vismRudpSessionSentPackets:
vismRudpSessionRcvdPackets:
vismRudpSessionSentBytes:
vismRudpSessionRcvdBytes:
vismRudpSessionDataSentPkts:
vismRudpSessionDataRcvdPkts:
vismRudpSessionDiscardPkts:
vismRudpSessionRetransPkts:
Related Commands
Command
addsesset
delsesset
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspsesstat session-num
Session number for which you want to display PRI backhaul session statistics. It can
be in the range from 1 to 64.
Description
Adds a PRI backhaul session set between a VISM card and a call agent.
Deletes a PRI backhaul session set.
1
0
0
0
0
5
0
0
0
0
0
0
0
Cisco VISM Installation and Configuration Guide
dspsesstat
5-427
Advertisement
Table of Contents
