cnfendptcadence
cnfendptcadence
To configure cadence (digit tone) times for an endpoint, use the cnfendptcadence command in the VoIP
switching/trunking and AAL2 trunking operating modes.
Syntax Description
endpt-num
tone-on-time
tone-off-time
Command Modes
VoIP switching/trunking and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that endpoint 20 is configured with 100 ms digit tone generation time
length and 100 ms silence time length between generated tones:
cnfendptcadence 20 100 100
Related Commands
There are no related commands.
Cisco VISM Installation and Configuration Guide
5-148
cnfendptcadence endpt-num tone-on-time tone-off-time
Endpoint number. It can be a value from one of the following ranges:
For template number 1:
•
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 2:
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
For template number 3:
•
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
•
For template number 4:
–
For VISM-PR, from 1 to 144
Length of time (defined in milliseconds) a digit tone is generated. It can be in the
range from 2 to 9999. (Default = 75)
Length of time (defined in milliseconds) silence is maintained between digit tone
generation. It can be in the range from 0 to 9999. (Default = 75)
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands