Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfsesmaxwindow
To configure the maximum number of segments (window) that can be sent before receiving an
acknowledgment, use the cnfsesmaxwindow command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
window-size
Command Modes
VoIP switching/trunking
Usage Guidelines
Use this command for a previously added PRI backhaul session.
Examples
The following example shows that a maximum number of 44 segments can be sent for session number 2
before receiving an acknowledgment:
cnfsesmaxwindow 2 44
Related Commands
Command
cnfsesack
cnfsesmaxreset
cnfsesmaxseg
cnfsesnullsegtmout
cnfsesoutofseq
cnfsesport
cnfsesretrans
cnfsesstatetmout
cnfsessyncatmps
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfsesmaxwindow session-num window-size
Identifying session number in the range from 1 to 64.
Maximum number of segments that can be sent before receiving an
acknowledgment. It can be in the range from 1 to 64.
Description
Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
Configures the maximum number of resets that a VISM card performs before
a connection is reset.
Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
Configures the idle time before sending a null segment.
Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
Configures the port numbers of a previously added PRI backhaul session.
Configures the timeout period for unacknowledged packets and the number
of retransmissions.
Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
Configures the maximum number of call agent synchronization attempts.
Cisco VISM Installation and Configuration Guide
cnfsesmaxwindow
5-207
Advertisement
Table of Contents
