Table of Contents
Advertisement
delport
delport
To delete the VISM port on the packet network side, use the delport command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
You should execute this command before you remove the VISM card.
Caution
If you remove a VISM card with an undeleted port, subsequent cards inserted into the same slot may
not operate correctly. You should delete the resource partition and all PVCs before deleting the port.
When you use this command, the entry with the following port numbers is deleted in the following
manner:
•
•
Examples
The following example shows that the VISM port on the packet network side is deleted:
delport
Related Commands
Command
dspport
Cisco VISM Installation and Configuration Guide
5-266
delport
Entry 1 is deleted from a PXM1 card
Entry 255 is deleted from a PXM1E card
Description
Displays data about the virtual port that was created using the addport command.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
