Table of Contents
Advertisement
Chapter 5
CLI Commands
cnflngain
To configure the adjustable gain for all DS0s on a specified VISM card line, use the cnflngain
(Configure Line Gain) command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2
trunking operating modes.
Syntax Description
line-num
input-gain
output-atten
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the VISM card line number 2 is configured with a –10-dB input gain
value and a 60-dB output attenuation value:
cnfgain 2 -10 60
Related Commands
Command
cnfds0gain
cnfgain
cnfplngain
dspds0gain
dspgain
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnflngain line-num input-gain output-atten
Line number that you want to configure the adjustable gain. In the range from 1 to 8.
Input gain (defined in decibels). It can be in the range from –60 to 140 in increments
of 10.
Output attenuation (defined in decibels). It can be in the range from 0 to 140 in
increments of 10.
Description
Configures the adjustable gain for a specified DS0.
Configures the adjustable gain for a VISM card.
Configures the adjustable gain for a specified VISM card line.
Displays the adjustable gain values for a specified DS0.
Displays the adjustable gain for a specified VISM card.
Cisco VISM Installation and Configuration Guide
cnflngain
5-167
Advertisement
Table of Contents
