Configuring Vism Features; Initial Vism Configuration - Cisco Voice Interworking Services (VISM) Installation And Configuration Manual

Configuring VISM Features

Configuring VISM Features
The CLI allows you to configure all features and functions of VISM. Configure mandatory commands
when you require argument values that are different from the default. Configure optional commands
when necessary.
Perform the following tasks with CLI commands to enable your VISM card applications:
1.
2.
3.
4.
5.
6.

Initial VISM Configuration

You must execute a sequence of mandatory commands, specific to your operating mode, to make the
VISM card fully operational. The mandatory commands for each operating mode are listed in
in order of execution. The remainder of this chapter assists you with using these commands, and
commands specific to your operating system.
Cisco VISM Installation and Configuration Guide
4-6
Perform the mandatory initial VISM configuration.
Perform the initial card-level configuration.
Configure the TDM side.
Configure bearer processing.
Configure one type of signaling—CAS or CCS—for each application.
Note
Configure the ATM network side.
Configure the call agent interface.
If you are using a VoIP or an AAL2 trunking application, do not configure a call agent
Note
interface.
Chapter 4 Configuring VISM Features
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Table 4-2