Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 521

Chapter 5 CLI Commands
dsplntonetimeout
To display the configured timeout periods for all call progress tones of a specified VISM card line, use
the dsplntonetimeout command in the VoIP switching/trunking and switched AAL2 PVC operating
modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines Follow standard CLI procedures for this command.
Examples
The following example shows that all call progress tones for the current VISM card line number 5 are
displayed, in seconds:
dsplntonetimeout 5
LineNum:
Dsx1RingingTO:
Dsx1RingBackTO:
Dsx1BusyTO:
Dsx1ReorderTO:
Dsx1DialTO:
Dsx1StutterDialTO:
Dsx1OffHookAlertTO: 5 seconds
Related Commands Command
addtoneplan
cnflnringback
cnflntoneplan
cnflntonetimeout
dellntoneplan
deltoneplan
dsplnringback
dsplntoneplan
dsptonebuiltinplans Displays all preconfigured (built-in) tone plans on the current VISM card.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsplntonetimeout line-num
Line number for which you want to display the configured timeout periods
(defined in seconds) for all call progress tones. It can be in the range from 1 to
8.
5
200 seconds
200 seconds
35 seconds
35 seconds
16 seconds
16 seconds
Description
Adds a tone plan to the current VISM card.
Configures the ringback tone method for a specified line on the current VISM
card.
Assigns a tone plan to a specified VISM card line.
Modifies the timeout periods of all call progress tones supported by VISM on
a specified VISM card line.
Deletes the tone plan configuration of a specified VISM card line.
Deletes a previously added tone plan from the current VISM card.
Displays the ringback tone method for a specified line on the current VISM
card.
Displays the tone plan configuration of a specified VISM card line.
Cisco VISM Installation and Configuration Guide
dsplntonetimeout
5-377