Table of Contents
Advertisement
cnflntrunkcond
cnflntrunkcond
To enable or disable line conditioning on a VISM card line if a network alarm is encountered, use the
cnflntrunkcond command in the VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
operating modes.
Syntax Description
line-num
cond-enable
Command Modes
VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines
Trunk conditioning consists of sending 0x7f or 0xff on the affected DS0s for T1 or E1 respectively. In
addition, in the case of T1, the idle code pattern is transmitted for 2 to 5 seconds followed by the seized
code pattern, as specified in the cnfcascode command.
This command is not allowed if endpoints or CCS channels are enabled on the line.
Examples
The following example shows that line 2 is configured with line conditioning if an AAL2 alarm is
encountered:
cnflntrunkcond 2 1
Related Commands
Command
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
cnfrtpcon
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
dellapdtrunk
delrtpcon
delrudptrunk
Cisco VISM Installation and Configuration Guide
5-178
cnflntrunkcond line-num cond-enable
Line number for which you want enable or disable line conditioning. In the
range from 1 to 8.
Line trunk conditioning status. It can be one of the following options:
1 = Enable. VISM performs trunk conditioning on each affected DS0 if an
•
alarm occurs on the ATM side.
2 = Disable. VISM sends an alarm indication signal (AIS), blue alarm, or
•
RAI to the line if an alarm occurs on the ATM side.
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Modifies an existing static RTP VoIP trunking connection.
trunk for a specified session.
Deletes an LAPD configured line.
Deletes a static RTP VoIP trunking connection.
Deletes an ISDN PRI backhaul RUDP session that is associated with an LAPD.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
