Table of Contents
Advertisement
addendpts
This command sends an RSIP message to each associated call agent indicating that the endpoints are in
service.
Examples
The following example shows that 12 consecutive endpoints are added to line 1, starting at endpoint
number 6, DS0 number 12:
addendpts 6 1 12 12
Related Commands
Command
delendpts
dspendpts
Cisco VISM Installation and Configuration Guide
5-24
Description
Deletes a consecutive number of endpoints on the VISM card.
Displays information about all endpoints on a VISM card.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
