Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfsesmaxreset
To configure the maximum number of resets that a VISM card performs before a connection is reset, use
the cnfsesmaxreset command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
max-resets
Command Modes
VoIP switching/trunking
Usage Guidelines
Use this command for a previously added PRI backhaul session.
Examples
The following example shows that 25 is the maximum number of resets configured for session number 2:
cnfsesmaxreset 2 25
Related Commands
Command
cnfsesack
cnfsesmaxseg
cnfsesmaxwindow
cnfsesnullsegtmout
cnfsesoutofseq
cnfsesport
cnfsesretrans
cnfsesstatetmout
cnfsessyncatmps
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfsesmaxreset session-num max-resets
Identifying session number in the range from 1 to 64.
Maximum number of resets that the VISM card performs before a
connection is reset. It can be in the range from 0 to 255. (Default = 3)
Description
Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
Configures the maximum number of segments (window) that can be sent
before receiving an acknowledgment.
Configures the idle time before sending a null segment.
Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
Configures the port numbers of a previously added PRI backhaul session.
Configures the timeout period for unacknowledged packets and the number
of retransmissions.
Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
Configures the maximum number of call agent synchronization attempts.
Cisco VISM Installation and Configuration Guide
cnfsesmaxreset
5-205
Advertisement
Table of Contents
