Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 566

dspses
dspses
To display the configuration data of a Primary Rate Interface (PRI) backhaul session, use the dspses
command in the VoIP switching/trunking and switched AAL2 PVC operating mode.
Syntax Description
session-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples The following example shows that the configuration data of PRI backhaul session number 1 is displayed:
dspses 1
vismRudpSessionNum:
vismRudpSessionGrpNum:
vismRudpSessionPriority:
vismRudpSessionState:
vismRudpSessionCurrSession:
vismRudpSessionLocalIp:
vismRudpSessionLocalPort:
vismRudpSessionRmtIp:
vismRudpSessionRmtPort:
vismRudpSessionMaxWindow:
vismRudpSessionSyncAttempts:
vismRudpSessionMaxSegSize:
vismRudpSessionMaxAutoReset:
vismRudpSessionRetransTmout:
vismRudpSessionMaxRetrans:
vismRudpSessionMaxCumAck:
vismRudpSessionAckTmout:
vismRudpSessionMaxOutOfSeq:
vismRudpSessionNullSegTmout:
vismRudpSessionTransStateTmout: 2000
Related Commands Command
addses
delses
dspsess
Cisco VISM Installation and Configuration Guide
5-422
dspses session-num
Identifying session number in the range from 1 to 64.
Description
Adds a PRI backhaul session between a VISM card and a call agent.
Deletes a PRI backhaul session.
Displays the configuration data of all PRI backhaul sessions.
1
1
1
Oos
0
xxx.xx.xx.xxx
1124
xxx.xx.xx.xx
1124
32
5
384
5
600
3
3
300
4
2000
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5 CLI Commands