Table of Contents
Advertisement
Chapter 4
Configuring VISM Features
endpt-num: Type the value used in
•
dial-delay: In the range from 10 to 1000
•
To configure CAS for the switched AAL2 PVC operating mode, proceed to
Step 8
for the AAL2 trunking operating mode, proceed to
Type the cnfcascode command, endpt-num, |endpt-num|, idle-code, and seized-code argument values
Step 9
and press Enter to specify the idle and seized codes for one or more endpoints. Specify the arguments
with the following values:
endpt-num: Type the value used in
•
Note
|endpt-num|:
•
–
–
–
–
Note
idle-code (4-bit idle code): In the range from 0 to 15 represents the four A, B, C, and D signaling as
•
bits 3, 2, 1, and 0 respectively with bit 3 the most significant.
•
seized-code (4-bit seized code): In the range from 0 to 15 represents the four A, B, C, and D
signaling as bits 3, 2, 1, and 0 respectively with bit 3 the most significant.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
If the |endpt-num| optional argument value is used in combination with this argument,
the endpt-num argument value is the first endpoint in a consecutive range of endpoints.
For template number 1:
For VISM, in the range from 1 to 145
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
For template number 2:
For VISM T1, in the range from 1 to 192
For VISM E1, in the range from 1 to 248
For template number 3:
For VISM, in the range from 1 to 120
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
For template number 4:
For VISM-PR, in the range from 1 to 144
The |endpt-num| optional argument value indicates the last endpoint in a consecutive
range of endpoints.
Step
1.
Step
9.
Step
1.
Cisco VISM Installation and Configuration Guide
Configuring VISM Features
Step
11. To configure CAS
4-25
Advertisement
Table of Contents
