Table of Contents
Advertisement
Chapter 5
CLI Commands
addlnloop
To set a specified line of the current card to the local loopback state, use the addlnloop command in the
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
The VISM CLI has no specific command for setting a line to a remote loopback state. To set a line
Note
to remote loopback state, use the cnfbert command on the PXM card. Refer to MGX 8000 Series
platform command line interface guides for more information.
Examples
The following example adds a local line loopback state to line 1:
addlnloop 1
Related Commands
Command
dellnloop
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
addlnloop line-num
Line number of the T1 or E1 line to be added in the range from 1 to 8.
Description
Deletes a T1 or E1 local line loopback state for the VISM card.
Cisco VISM Installation and Configuration Guide
addlnloop
5-29
Advertisement
Table of Contents
