Table of Contents
Advertisement
Chapter 5
CLI Commands
dsprudptrunk
To display the configuration data of a specified ISDN PRI backhaul Reliable User Datagram Protocol
(RUDP) session, use the dsprudptrunk command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data of ISDN PRI backhaul RUDP session number
43 is displayed:
dsprudptrunk 43
Session Number
Local Port
.
.
Trans State Timeout:2000
Related Commands
Command
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
cnflntrunkcond
cnfrtpcon
cnfrudptrunkrmtip Modifies the remote IP address of VISM used in the ISDN PRI backhaul RUDP
dellapdtrunk
delrtpcon
delrudptrunk
dsplapd
dsplapdtrunkpvc
dsplapdtrunks
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsprudptrunk session-num
Identifying session number in the range from 1 to 64.
:43
:1124
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
Modifies an existing static RTP VoIP trunking connection.
trunk for a specified session.
Deletes an LAPD configured line.
Deletes a static RTP VoIP trunking connection.
Deletes an ISDN PRI backhaul RUDP session that is associated with an LAPD.
Displays data about an LAPD.
Displays the assigned PVC trunk type that carries LAPD trunk messages for
the current VISM card.
Displays the configuration data of all LAPD trunks.
Cisco VISM Installation and Configuration Guide
dsprudptrunk
5-415
Advertisement
Table of Contents
