Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfrtprxtimer
To enable or disable the receipt of Real-Time Transport Protocol (RTP) messages on a VISM card, use the
cnfrtprxtimer command in the VoIP switching/trunking operating mode.
Syntax Description
rx-timer
Command Modes
VoIP switching/trunking
Usage Guidelines
If you enable the receipt of RTP messages (rx-timer = 2) and no RTP messages are received on a
particular connection for 5 seconds, the gateway initiates a connection deletion. You cannot configure
the 5-second time limit.
Examples
The following example shows that the receipt of RTP messages is enabled for the current VISM card:
cnfrtprxtimer 2
Related Commands
There are no related commands.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfrtprxtimer rx-timer
Enables or disables the receipt of RTP messages. It can be one of the following
values:
•
1 = Disable
2 = Enable
•
Cisco VISM Installation and Configuration Guide
cnfrtprxtimer
5-201
Advertisement
Table of Contents
