Table of Contents
Advertisement
addport
addport
To add a virtual port between the VISM and PXM cards, use the addport command in the VoIP
switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, and AAL1/VoIP
(for TDM grooming) operating modes.
Syntax Description
This command has no arguments.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, AAL2 trunking, AAL1 SVC, AAL2 SVC, and
AAL1/VoIP (for TDM grooming)
Usage Guidelines
This command automatically associates the VISM card and the virtual port with the MGX 8000 Series
platform.
Note
If the VISM card is reset after executing this command but before executing the addrscprtn
command, an error message is displayed. The error has no effect on the system and can be ignored.
The port number is set to one of the following when you use this command:
•
•
Examples
The following example shows that a virtual port has been added between the VISM and PXM cards:
addport
Related Commands
Command
delport
Cisco VISM Installation and Configuration Guide
5-34
addport
1—for PXM1 cards
255—for PXM1E cards
Description
Deletes a VISM port on the packet network side.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
