Table of Contents
Advertisement
cnfmgcgrpentry
cnfmgcgrpentry
To modify the call agent priority level of a call agent within a call agent redundancy group, use the
cnfmgcgrpentry command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
operating modes.
Syntax Description
mgc-group
mgc-num
mgc-preference
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the call agent redundancy group number 1, call agent number 2, is
configured with a priority level of 4:
cnfmgcgrpentry 1 2 4
Related Commands
Command
addmgcgrpentry
addmgcgrpprotocol
cnfmgcgrpparam
cnfsrcppeer
cnfsrcppeergrpparam
delmgcgrpentry
delmgcgrpprotocol
dspmgcgrpparams
dspmgcgrpprotocols
dspmgcgrps
dspsrcppeergrpparams
Cisco VISM Installation and Configuration Guide
5-180
cnfmgcgrpentry mgc-group mgc-num mgc-preference
Call agent redundancy group number. It can be in the range from 1 to 8.
Call agent identification number. It can be in the range from 1 to 8.
Call agent priority value. It can be in the range from 1 (highest) to 8
(lowest).
Description
Configures call agents as part of an MGC redundancy group and assigns a
priority value for a call agent.
Associates a call agent redundancy group to a gateway control protocol.
Modifies a call agent redundancy group state change notification policy
and priority level.
Configures the SRCP parameters when SRCP is the selected protocol for
communication between the VISM card and call agent.
Modifies the SRCP heartbeat interval and maximum UDP size for a
specified call agent redundancy group.
Deletes a call agent from a call agent redundancy group.
Deletes an MGCP from a specified call agent redundancy group.
Displays all configured call agent redundancy group parameters.
Displays all configured call agent redundancy group protocols.
Displays all configured call agent redundancy groups.
Displays the SRCP parameters for all call agent redundancy groups that
have SRCP added.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
