Table of Contents
Advertisement
dsplnendptstatus
dsplnendptstatus
To display the status of endpoints for a specified T1 or E1 line, use the dsplnendptstatus command in
the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating mode.
Syntax Description
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the status for the endpoints on line 1 are displayed:
dsplnendptstatus 1
ds0# Endpt#
------------------------------
1
Related Commands
Command
dspendpts
dspln
Cisco VISM Installation and Configuration Guide
5-368
dsplnendptstatus line-num
Line number for which you want to display the status of endpoints. It can be in the
range from 1 to 8.
Codec
VAD
ECAN
1
G.711a
ON
ON
Description
Displays information about all the endpoints on a VISM card.
Displays the characteristics of a VISM card line.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
