Table of Contents
Advertisement
dspln
dspln
To display the configuration data of a VISM card line, use the dspln command in the VoIP
switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data for the current VISM card's line number 1 is
displayed:
dspln 1
LineNum:
LineConnectorType:
LineEnable:
LineType:
LineCoding:
LineLength:
LineXmtClockSource:
LineLoopbackCommand:
LineSendCode:
LineUsedTimeslotsBitMap:
LineLoopbackCodeDetection: codeDetectDisabled
LineSignalingType:
LineCcsChannels:
LineTrunkConditioning:
LineNumOfValidEntries: 8
The LineCcsChannels data applies only to the AAL2 trunking operating mode.
Note
Related Commands
Command
addln
cnfln
delln
Cisco VISM Installation and Configuration Guide
5-362
dspln line-num
Line number for which you want to display the configuration data. It can be in the
range from 1 to 8.
Description
Adds a T1 or E1 line to a VISM card.
Configures characteristics for a VISM card line.
Deletes a T1 or E1 line from a VISM card.
1
RJ-48
Enabled
dsx1ESF
dsx1B8ZS
0-131 ft
LocalTiming
NoLoop
NoCode
0x3ff
CAS
0x0
disable
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
