Table of Contents
Advertisement
cnfsesnullsegtmout
cnfsesnullsegtmout
To configure the timeout period, in milliseconds, of idle time before a null segment is sent, use the
cnfsesnullsegtmout command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
null-seg-tout
Command Modes
VoIP switching/trunking
Usage Guidelines
Use this command for a previously added PRI backhaul session.
Examples
The following example shows that the idle timeout period is configured at 1000 ms for session number 2:
cnfsesnullsegtmout 2 1000
Related Commands
Command
cnfsesack
cnfsesmaxreset
cnfsesmaxseg
cnfsesoutofseq
cnfsesport
cnfsesretrans
cnfsesstatetmout
cnfsessyncatmps
Cisco VISM Installation and Configuration Guide
5-208
cnfsesnullsegtmout session-num null-seg-tout
Identifying session number in the range from 1 to 64.
Timeout period (defined in milliseconds) of idle time before a null segment
is sent. It can be in the range from 0 to 65535.
Description
Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
Configures the maximum number of resets that a VISM card performs before
a connection is reset.
Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
Configures the port numbers of a previously added PRI backhaul session.
Configures the timeout period for unacknowledged packets and the number
of retransmissions.
Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
Configures the maximum number of call agent synchronization attempts.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
