Table of Contents
Advertisement
Chapter 4
Configuring VISM Features
–
–
–
start-line-num (DS1 line): In the range from 1 to 8
•
start-ds0-num (DS0 channel):
•
–
–
–
•
endpt-quantity:
–
–
–
–
Type the addendptloop command, an endpt-num argument value, and press Enter to place a specific
Step 3
endpoint—and so a specific DS1/DS0—into the loopback state in the TDM direction. Specify the
endpt-num argument value from the following ranges:
For template number 1:
•
–
–
–
•
For template number 2:
–
–
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
For template number 2:
For VISM T1, in the range from 1 to 192
For VISM E1, in the range from 1 to 248
For template number 3:
For VISM, in the range from 1 to 120
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
For template number 4:
For VISM-PR, in the range from 1 to 144
For T1 lines, from 1 to 24
For non-CAS E1 lines, from 1 to 31
For CAS E1 lines, from 1 to 15 and 17 to 31
For template number 1:
For VISM, in the range from 1 to 145
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
For template number 2:
For VISM T1, in the range from 1 to 192
For VISM E1, in the range from 1 to 248
For template number 3:
For VISM, in the range from 1 to 120
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
For template number 4:
For VISM-PR, in the range from 1 to 144
For VISM, in the range from 1 to 145
For VISM-PR T1, in the range from 1 to 192
For VISM-PR E1, in the range from 1 to 248
For VISM T1, in the range from 1 to 192
For VISM E1, in the range from 1 to 248
Cisco VISM Installation and Configuration Guide
Configuring VISM Features
4-19
Advertisement
Table of Contents
