Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfnwcot
To configure VISM for a gateway-initiated network continuity test, use the cnfnwcot command in the
VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
co3test-enable
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
This command configures VISM for gateway-initiated network continuity testing. When enabled, and
after VISM receives the remote SDP information, VISM sends an Named Signaling Event (NSE) or
AAL2 type 3 packet (CO3) towards the network. If the other gateway does not respond with a NSE/Type
3 packet (CO4), the connection is deleted. VISM interprets that the gateway initiated DLCX, with a
reason code of "Network cont. failed," is sent to the call agent.
Examples
The following example shows that VISM is configured for a gateway-initiated network continuity test:
cnfnwcot 1
Related Commands
Command
cnfco4timer
dspco4timer
dspnwcot
dspvismparam
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfnwcot co3test-enable
Enables or disables the VISM-initiated CO3 network continuity test. It can be
one of the following values:
•
1 = On
2 = Off (Default)
•
Description
Configures the bearer continuity test CO4 timer value.
Displays the bearer continuity test CO4 timer value.
Displays the status—enabled or disabled—of the gateway initiated network
continuity test configuration for VISM.
Displays the current VISM card configuration.
Cisco VISM Installation and Configuration Guide
cnfnwcot
5-187
Advertisement
Table of Contents
