Table of Contents
Advertisement
cnflapdretrans
cnflapdretrans
To configure a maximum number of frame retransmissions for a previously added Link Access Protocol
D channel (LAPD), use the cnflapdretrans command in the VoIP switching/trunking operating mode.
Syntax Description
line-num
ds0-num
n200
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that line 2, DS0 12 is configured with a maximum number of 10 frame
retransmission attempts:
cnflapdretrans 2 12 10
Related Commands
Command
cnflapdtimer
cnflapdtype
cnflapdwinsize
Cisco VISM Installation and Configuration Guide
5-156
cnflapdretrans line-num ds0-num n200
Line number of the D channel to be configured. In the range from 1 to 8.
DS0 number that was specified in the addlapd command. It can be a value
from one of the following ranges:
1 to 24 for T1 lines
•
1 to 31 for E1 lines
•
Maximum frame retransmissions in the range from 1 to 10.
Description
Configures two LAPD timers for a previously added LAPD.
Configures the various types of LAPD stacks for a previously added LAPD.
Configures the maximum number of outstanding (unacknowledged) I-frames.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
