Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 357

Voice interworking service module release 3.0
Table of Contents

Advertisement

Chapter 5
CLI Commands
cnfsessyncatmps
To configure the maximum number of attempts to synchronize with the call agent, use the
cnfsessyncatmps command in the VoIP switching/trunking operating mode.
Syntax Description
session-num
max-sync-attempts
Command Modes
VoIP switching/trunking
Usage Guidelines
Use this command for a previously added PRI backhaul session.
Examples
The following example shows that session number 2 is configured with a maximum of 10
synchronization attempts with the call agent:
cnfsessyncatmps 2 10
Related Commands
Command
cnfsesack
cnfsesmaxreset
cnfsesmaxseg
cnfsesoutofseq
cnfsesport
cnfsesretrans
cnfsesstatetmout
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfsessyncatmps session-num max-sync-attempts
Identifying session number in the range from 1 to 64.
The maximum number of attempts to synchronize with the call agent. It can
be in the range from 1 to 32.
Description
Configures the timeout period before sending an acknowledgment, and the
maximum number of acknowledgments that can be accumulated.
Configures the maximum number of resets that a VISM card performs before
a connection is reset.
Configures the maximum segment size, in octets, that can be received by a
VISM card after sending a synchronize message.
Configures the maximum number of out-of-sequence packets that can be
accumulated before sending an EACK packet.
Configures the port numbers of a previously added PRI backhaul session.
Configures the timeout period for unacknowledged packets and number of
retransmissions.
Configures the number of milliseconds that VISM waits for a transfer state
before executing an auto reset.
Cisco VISM Installation and Configuration Guide
cnfsessyncatmps
5-213

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vism 3.0

Table of Contents