Chapter 5
CLI Commands
cnflapdtype
To configure the various types of Link Access Protocol D channel (LAPD) stacks for a previously added
LAPD, use the cnflapdtype command in the VoIP switching/trunking operating mode.
Syntax Description
line-num
ds0-num
lapd-type
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that line 2, DS0 12 is configured with the AUSP LAPD stack type:
cnflapdtype 2 12 12
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnflapdtype line-num ds0-num lapd-type
Line number of the D channel to be configured. In the range from 1 to 8.
DS0 number that was specified in the addlapd command. It can be a value from one of
the following ranges:
1 to 24 for T1 lines
•
1 to 31 for E1 lines
•
Type of LAPD stack to configure on the specified line and DS0. It can be one of the
following values:
•
1 = ITU
•
3 = ATT5ESSPRA
•
4 = ATT4ESS
•
6 = NTDMS100PRA
•
7 = VN2 or 3
8 = INSNet
•
9 = TR6MFC
•
•
10 = TR6PBX
12 = AUSP
•
•
13 = NIL
•
14 = SSETSI
•
15 = BC303TMC
16 = BC303CSC
•
17 = NTDMS250
•
18 = Bellcore
•
19 = NI2
•
Cisco VISM Installation and Configuration Guide
cnflapdtype
5-161