Table of Contents
Advertisement
Chapter 5
CLI Commands
dspt38fxlcos
To display the fax handling instructions for all lines on the current VISM card, use the dspt38fxlcos
command in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
This command has no arguments or keywords.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the fax handling instructions for all lines on the current VISM card
are displayed:
dspt38fxlcos
Line_Number
-----------
1
2
.
.
.
8
Related Commands
Command
cnfcodectmpl
cnft38fxlco
cnft38nsetimeout
cnft38params
dspcodectmpls
dspt38fxlco
dspt38nsetimeout
dspt38nsetimeouts
dspt38params
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspt38fxlcos
Fx LCO
------
Gateway controlled preferred then pass-through
Gateway controlled preferred then pass-through
Gateway controlled preferred then pass-through
Description
Assigns a codec template to an entire VISM card.
Configures the fax handling instructions for a specified line.
Configures a specified line with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
Configures the T.38 fax transfer parameters for a specified line.
Displays all entries in the codec template table.
Displays the fax handling instructions configured for a specified line.
Displays a specified configured line with a length of time in which to wait for
a remote acknowledgment of the offer to switch to fax transfer mode.
Displays all configured lines with a length of time in which to wait for a remote
acknowledgment of the offer to switch to fax transfer mode.
Displays the T.38 fax transfer parameters for a specified line.
Cisco VISM Installation and Configuration Guide
dspt38fxlcos
5-437
Advertisement
Table of Contents
