Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 515

Voice interworking service module release 3.0
Table of Contents

Advertisement

Chapter 5
CLI Commands
dsplnringback
To display the ringback tone method for a specified line on the current VISM card, use the
dsplnringback command in the VoIP switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
line-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
The ringback tone method is displayed as one of the following:
Examples
The following example shows that the current VISM card line 4 ringback tone method, inband, is
displayed:
dsplnringback 4
LineNum: 4
Dsx1RemoteRingback: inband
Related Commands
Command
addtoneplan
cnflnringback
cnflntoneplan
cnflntonetimeout
dellntoneplan
deltoneplan
dsplntoneplan
dsplntonetimeout
dsptonebuiltinplans Displays all preconfigured (built-in) tone plans on the current VISM card.
dsptoneplan
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsplnringback line-num
Line number for which you want to display the ringback method. In the range
from 1 to 8.
Proxy—VISM sends the appropriate packet (NSE, NTE, or AAL2 type 3) for the ringback tone to
the originating VISM which generates the ringback tone toward the TDM network.
Inband—VISM generates the inband ringback tone toward the originating VISM over the packet
network and the originating VISM plays the ringback tone.
Description
Adds a tone plan to the current VISM card.
Configures the ringback tone method for a specified line on the current VISM
card.
Assigns a tone plan to a specified VISM card line.
Modifies the timeout periods of all call progress tones supported by VISM on
a specified VISM card line.
Deletes the tone plan configuration of a specified VISM card line.
Deletes a previously added tone plan from the current VISM card.
Displays the tone plan configuration of a specified VISM card line.
Displays the configured timeout periods for all call progress tones of a
specified VISM card line.
Displays the tone configuration of a specified tone plan—either a
preconfigured (built-in) or user-added tone plan.
Cisco VISM Installation and Configuration Guide
dsplnringback
5-371

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vism 3.0

Table of Contents