Table of Contents
Advertisement
cnfvoiptransparams
cnfvoiptransparams
To configure the VoIP transportation parameters—enable dual tone multifrequency (DTMF) and channel
associated signaling (CAS) bits transportation to the other endpoint, configure the Named Signaling
Event (NSE) triple redundancy feature for NSE packets, and optionally configure the event negotiation
policy and silence insertion descriptor (SID) payload type—use the cnfvoiptransparams command in
the VoIP switching/trunking operating mode.
Syntax Description
dtmf-trans
cas-trans
event-neg-enable
event-neg-pol
sid-type
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that DTMF and CAS bit transportation are enabled and the NSE
redundancy feature is not enabled:
cnfvoiptransparams 1 1 2
Cisco VISM Installation and Configuration Guide
5-232
cnfvoiptransparams dtmf-trans cas-trans |event-neg-enable event-neg-pol sid-type|
Enables or disables DTMF tone transportation. It can be one of the following
values:
•
1 = On
•
2 = Off
Note
The dtmf-trans argument value must be set to 1 (on) when you are using
codecs other than G.711 and G.726.
Enables or disables CAS signaling transportation. It can be one of the following
values:
•
1 = On
•
2 = Off
(Optional) Enables or disables whether VISM should negotiate how to send
events. It can be one of the following values:
1 = On. Attempt to negotiate how to send events.
•
2 = Off. Do not attempt to negotiate how to send events.
•
(Optional) Event negotiation policy. It can be one of the following values:
•
1 = None. Call agent driven.
•
2 = Proprietary (Default). Call agent driven and VISM proprietary events.
•
3 = All. Call agent driven and all event codecs specified by VISM.
(Optional) SID payload type. It can be in the range from 0 to 255. (Default = 13)
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
