Table of Contents
Advertisement
Chapter 5
CLI Commands
dspxgcpendpt
To display the attributes associated with an endpoint added using the addendpt command, or the SNMP
equivalent, use the dspxgcpendpt command in the VoIP switching/trunking and switched AAL2 PVC
operating modes.
Syntax Description
line-num
ds0-num
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
An endpoint added with the addendpt command is considered an xGCP endpoint even though a call
agent established connection cannot be associated with the endpoint.
Examples
The following example shows that the statistics for the endpoint identified by line number 1, DS0
number 1 are displayed:
dspxgcpendpt 1 1
*********************************************************
*********************************************************
Line Number
Endpoint Number
Endpoint Name
Continuity Test
Echo Cancellation
Protocol Version
MGC IP Address
MGC UDP Port
Port in Notified Entity
Request ID
Quarantine Handling
Requested Event List
Signal Event List
Accumulated Event List
Quarantined Event List
Detect Event List
Accumulated Dialed String
DSP Channel Connected to Network Endpoint
Retry Count
Minimum Retry Timeout
Maximum Retry Timeout
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspxgcpendpt line-num ds0-num
Line number of the endpoint for which you want to display the attributes. It can be in
the range from 1 to 8.
DS0 number of the endpoint for which you want to display the attributes. It can be a
value from one of the following ranges:
•
1 to 24 for T1 lines
1 to 31 for E1 lines
•
Attributes of Endpoint Name: vism/T1-1/1
= 1
= 1
= vism/T1-1/1
= FALSE
= FALSE
= Invalid Protocol
= Unknown
= 0
= FALSE
= 0
=
=
=
=
=
=
=
= FALSE
= 3
= 500 ms
= 500 ms
Cisco VISM Installation and Configuration Guide
dspxgcpendpt
5-473
Advertisement
Table of Contents
