Table of Contents
Advertisement
Chapter 5
CLI Commands
cnfcompvad
To enable or disable voice activity detection (VAD) on a T1 or E1 line, use the cnfcompvad command
in the VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
line-num
vad-enable
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures when using this command.
Examples
The following example shows that line number 3 does not have VAD enabled:
cnfcompvad 3 2
Related Commands
There are no related commands.
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
cnfcompvad line-num vad-enable
Line number of the line on which to configure VAD in the range from 1 to 8.
Enables or disables VAD. It can be one of the following values:
1 = On
2 = Off
Cisco VISM Installation and Configuration Guide
cnfcompvad
5-125
Advertisement
Table of Contents
