Table of Contents
Advertisement
Chapter 5
CLI Commands
dspxgcpendptcons
To display the attributes of all connections associated with an endpoint added using the addendpt
command, or the SNMP equivalent, use the dspxgcpendptcons command in the VoIP
switching/trunking and switched AAL2 PVC operating modes.
Syntax Description
line-num
ds0-num
display-level
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the attributes of all connections associated by the endpoint identified
by line number 1, DS0 number 1 are displayed in the detailed format:
dspxgcpendptcons 1 1 2
*********************************************************
*********************************************************
Call ID
Endpoint Name
Line Number
Connection ID
Admitted Codec
Admitted Pkt. period
Connection Mode
Echo Cancellation
Type of Service
Network Type
Remote Address Type
Continuity Test
Loopback
Local RTP Port
Remote RTP Port
Remote RTP Port Count
Remote Address
Remote SDP
MGC Domain Name
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dspxgcpendptcons line-num ds0-num display-level
Line number of the endpoint connections for which you want to display the attributes.
It can be in the range from 1 to 8.
DS0 number of the endpoint connections for which you want to display the attributes.
It can be a value from one of the following ranges:
•
1 to 24 for T1 lines
1 to 31 for E1 lines
•
Detail level of display. It can be one of the following values:
1 = Abbreviated display.
•
2 = Detailed display.
•
Attributes of Connection ID:1
= 634
= vism/T1-1/1
= 1
= 1
= PCMU
= 10 ms
= sendrecv
= TRUE
= 0xa0
= IP
= Invalid (0)
= FALSE
= FALSE
= 49152
= 49154
= 1
= nn.nnn.n.n
= TRUE
= vsc-1
Cisco VISM Installation and Configuration Guide
dspxgcpendptcons
5-475
Advertisement
Table of Contents
