Table of Contents
Advertisement
dspcid
dspcid
To display the configuration data of an AAL2 channel identifier (CID) on the current VISM card, use
the dspcid command in the switched AAL2 PVC and AAL2 trunking operating modes.
Syntax Description
lcn
cid-num
Command Modes
Switched AAL2 PVC and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data of the AAL2 CID identified by LCN 131 and
CID 101 is displayed:
dspcid 131 101
LCN number :
Related Commands
Command
addcid
delcid
dspcids
Cisco VISM Installation and Configuration Guide
5-324
dspcid lcn cid-num
The logical channel number of the LCN/CID pair in the range from 131 to 510.
The channel identification number of the LCN/CID pair in the range from 8 to 255.
131
CID number:
101
Endpoint number :
1
CidRowStatus:
active
Type3redundancy:
enabled
VAD:
enabled
VADInitTimer:
250
Profile type:
ITU
Profile number:
2
Codec type:
G.711u
Cas transport:
enabled
DTMF transport:
enabled
Ecan on/off:
enabled
ICS enable:
Disabled
pkt period:
5
Cid state:
Active
Description
Adds an AAL2 CID on a VISM card.
Deletes the association between an endpoint and an LCN/CID pair.
Displays all AAL2 CIDs for a specified LCN on a VISM card.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
